
12
OPERATION
Using the Appliance
Before the rst cycle, set the appliance to dry for ve
minutes to warm up the drum. Open the door between
loads the rst few times you use the appliance to allow
any odours from the interior of the appliance to disperse.
1
Ensure the lint lter and water container are clean.
•
The lint lter is inside the door rim. It needs to be
cleaned before each drying cycle.
•
Open the door and ensure the lint lter is clean.
If it is not, please clean the lint lter.
•
Also check if the water container needs to be
emptied for optimum drying results.
NOTE
•
In some instances, LED window may display
(Empty water symbol) and the appliance may stop
because the water container is full.
2
Place laundry into the drum after sorting.
•
The clothes should be sorted by fabric type and
dryness level and all the strings and belts of
clothes should be well tied and xed before being
put into the drum. Push the laundry to the back
to keep it away from the door seal. Otherwise,
the door seal and clothes may be damaged.
Close the door.
CAUTION
•
Be careful not to trap laundry between the door
and rubber seal.
3
Turn the power on.
•
Press the
Power
button. The indicator icon
above the button will become illuminated,
indicating that the appliance is all set to run.
4
Select the drying programme you want.
•
You can choose a programme by turning the
programme selector knob until the required
programme is indicated.
•
If you press the
Start/Pause
button without
choosing a programme, the appliance will
proceed with the Cotton programme. Please
refer to the programme table for the detailed
information.
5
Press the
Start/Pause
button.
6
After the cycle has nished, open the door and
remove the laundry.
7
Turn off the appliance.
•
Press the
Power
button.
WARNING
•
Do not drink the condensed water.
Comentarios a estos manuales