LG C Series Manual de usuario descargar pdf (Pagina 27)

Chapter 5. Programming keypad

5.3 Moving to other groups

z There are 4 different parameter groups as shown below.

Drive group

Function

group 1

Function

group 2

I/O group

Drive group Basic parameters necessary for the inverter to run. Parameters such

as Target frequency and Accel/Decel time are settable.

Function group 1 Basic function parameters to adjust output frequency and voltage.

Function group 2 Advanced function parameters to set parameters for such as PID

Operation and second motor operation.

I/O (Input/Output)

group

Parameters necessary to make up a sequence using Multi-function

input/output terminal.

Moving to other parameter groups is only available in the first code of each group as

the figure shown below.

Moving to other groups using the Right (X) key Moving to other groups using the Left (W) key

Function

group 1

Function

group 2

I/O group

Drive group

Function

group 1

Function

group 2

I/O group

Drive group

* Target frequency can be set at 0.0 (the 1

code of drive group). Even though the preset value is 0.0, it is user-settable.

The changed frequency will be displayed after it is changed.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 126 127

Sin comentarios

LG C Series Manual de usuario Pagina 27