- About more information of IO Module, please refer to IO Module
manual.
CAUTION
Be sure to turn off outdoor unit power before installation.
!
+
+
※Pictures may differ depending on the model.
• Initial display order
• Example) ARUN100LSS0
Order No Note
①
4~12 Model capacity
②
1 Cooling only
2 Heat pump
③
38 380V
46 460V
22 220V
④
1 Standard
5 Cold temperature area
6 Tropical
① ② ③ ④
10 2 38 1
Checking the setting of outdoor units
Checking according to dip switch setting
- You can check the setting values of the Master outdoor unit from the
7 segment LED.
The dip switch setting should be changed when the power is OFF.
Checking the initial display
The number is sequentially appeared at the 7 segment in 5 seconds
after applying the power. This number represents the setting condi-
tion. (For example, represents R410A 10HP)
Installation of IO Module(optional)
① Assemble IO Module and bracket.
② Fix the bracket on designated location with two clamp
cords(105mm).
③ Connect the connection wires according to the instructions.
(Please refer to Setting and Using Method)
21
ENGLISH
Example) Connection of transmission wire
[BUS type] [STAR type]
- Connection of communication
cable must be installed like
below figure between indoor
unit to outdoor unit.
- Abnormal operation can be
caused by communication de-
fect, when connection of com-
munication cable is installed like
below figure(STAR type).
Example) Connection of power and communication cable
4HP / 5HP / 6HP
Comentarios a estos manuales