LG ARNH763K3B2.ANWALUS Manual de usuario Pagina 23

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 51
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 22
Accessories Installation
ENGLISH
Hydro Kit Installation Manual 23
2
2
1
3
3
<Wire guide grooves>
Wall
Side
Wall
Side
Wall
Side
Wall
Side
<Connecting order>
<Separating order>
Installation of Wired Remote Controller
1. Please fix tightly using provided screw after
placing remote controller setup board on the
place where you like to setup.
- Mount on a flat surface do not torque or bend the
PCB board while installing.
- If the wired remote controller is being attached to
a handy box, mount the wired remote controller
subbase with threaded screws to the box.
2. Wired remote controller cable termination op-
tions.
- The cable may be connected to the wired remote
controller from the rear, the top edge and the right
side of the subbase.
- If using the top right corner entry points, snap off
the plastic tab with needle nose pliers as shown.
Rear entry point
Top entry
Right side entry
3. Please fix remote controller body to the sub-
base attached to the surface of the wall, Snap
the comptroller body onto the subbase by gen-
tly pressing along the bottom edge of the de-
vice.
Two remove the controller body from the sub-
base, insert a small flat blade screw driver into
the two slots along the bottom edge of the sub-
base and gently turn clockwise to bend the
keeping tabs. Concurrently gently pull on the
bottom of the controller body and rotate up.
- Please individually separate one at a time.
- Please be careful not to damage the inside
components when separating.
Vista de pagina 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 50 51

Comentarios a estos manuales

Sin comentarios